OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0112

Intake Air Temperature Sensor 1 Circuit Low Bank 1

Intake air temperature sensor 1 is the first air temperature sensor in the intake path; depending on the vehicle it is built into the mass air flow sensor, mounted near the air filter or, on some naturally aspirated GM engines, fitted in the intake manifold. Most versions are NTC thermistors in a 5 V divider: the hotter the air, the lower the signal voltage. P0112 means the signal is below its valid range. With an NTC sensor that points to a short to ground in the signal wire or an internally shorted sensor, and the control module would read an implausibly hot value (GM about 150 °C). Documented limits: Ford petrol below 0.244 V for 5 s, Ford diesel below 0.10 V, GM below 62 ohms. The circuit is monitored continuously; GM needs two trips. Some systems then use the coolant temperature, capped at 40 °C, as a substitute and limit torque.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 12

Possible causes

  • Signal wire shorted to ground (chafed insulation) high
  • Sensor shorted internally high
  • Moisture or corrosion in the connector medium
  • Engine control module faulty low

Symptoms

  • Check engine light on
  • Usually hardly noticeable
  • Retarded ignition, reduced power or torque limit on some systems
  • Harder cold start possible

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0112

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication