OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0110

Intake Air Temperature Sensor 1 Circuit Bank 1

Intake air temperature sensor 1 is the first air temperature sensor in the intake path; depending on the vehicle it is built into the mass air flow sensor, mounted near the air filter or, on some naturally aspirated GM engines, fitted in the intake manifold. Most versions are NTC thermistors in a 5 V divider: the hotter the air, the lower the signal voltage. P0110 is the general circuit fault. With a conventional analogue sensor most manufacturers report low and high signals separately (P0112/P0113), so P0110 mainly appears in two cases: with digital (SENT) sensors that combine air mass and temperature, where it stands for lost communication or an implausible status (Ford diesel 2023, after about 5 s), and in some Bosch systems as a collective code whose fault type byte tells open circuit from short to ground. The control module then uses a substitute temperature; some systems also limit torque.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 10

Possible causes

  • Connector or wiring to the sensor open or corroded high
  • Sensor or mass air flow sensor with built-in temperature sensor faulty high
  • Sensor supply or ground disturbed medium
  • Engine control module faulty low

Symptoms

  • Check engine light on
  • Reduced power or torque limitation on some systems
  • Otherwise usually inconspicuous; cold start may be slightly worse

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0110

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication