OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P010F

Mass or Volume Air Flow Sensor A/B Correlation

Engines with two intake paths have two mass air flow sensors, A and B. On a symmetrical V engine both sides should draw about the same amount of air, so the readings can be compared with each other. P010F is set when both signals are electrically valid but differ by more than allowed; the code does not say which side is wrong. No manufacturer document using exactly this code or its threshold was found: GM's twin-turbo V6 and Nissan's VR30DDTT assess each sensor separately against a model (P0101/P010B). The description therefore rests on the CARB requirement for plausibility checks and on component sources for engines with two sensors. Typical causes are a leaking intake pipe or a soiled sensor on one side.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 0F

Possible causes

  • Air leak or loose intake pipe on one side high
  • One of the two sensors contaminated or aged high
  • Air filter on one side clogged or wrongly fitted medium
  • Turbocharger or boost problem on one bank low
  • Contact resistance in connector or wiring low

Symptoms

  • Check engine light on
  • Lack of power, uneven running
  • Mixture codes for one bank (P0171/P0174) possible

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P010F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication