P0108
Manifold Absolute Pressure/Barometric Pressure Sensor Circuit High
The manifold absolute pressure (MAP) sensor measures the pressure behind the throttle; on vehicles without a separate barometric sensor it also supplies the ambient pressure, read at key-on or wide-open throttle – hence 'MAP/BARO'. It is a three-wire sensor with 5 V reference, ground and signal. P0108 means the signal voltage is above its upper limit – typically an open ground (low reference), a signal wire shorted to 5 V or battery voltage, or a failed sensor. Like P0107 it describes the voltage, not real overpressure; genuinely excessive boost is P0234. Documented limits: GM petrol above 86 % of 5 V, GM diesel above 97 %, GM/Saab 2.0T above 4.80 V for 4 s, Ford above 4.88–4.96 V for 5 s. The engine substitutes a modelled value, which often makes the mixture too rich; turbo engines limit boost.
Possible causes
- Ground (low reference) wire open or connector corroded high
- Signal wire shorted to 5 V or battery voltage medium
- MAP sensor failed internally medium
- Engine control module faulty low
Symptoms
- Check engine light on
- Rich mixture, sooting, higher consumption
- Rough idle, loss of power or limp mode on turbo engines
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0108
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG03A Engine Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG04 Engine Diagnostics.pdf
- newtonnet.co.uk/fiesta/fordobd2012.pdf
- saabwisonline.com/9-5-9650/2011/2-engine/engine-management-and-fuel-system-2-0-l-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p0107-or-p0108