OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0107

Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Low

The manifold absolute pressure (MAP) sensor measures the pressure behind the throttle; on vehicles without a separate barometric sensor it also supplies the ambient pressure, read at key-on or wide-open throttle – hence 'MAP/BARO'. It is a three-wire sensor with 5 V reference, ground and signal. P0107 means the signal voltage is below its lower limit. 'Low' refers to the voltage, not to a real low pressure: typically the signal wire is grounded, the signal or 5 V reference is open, or the sensor has failed. A short on another sensor sharing the same reference can pull it down too, so GM often sees several codes at once. Documented limits: GM below 3.3 % of 5 V (about 0.17 V), GM/Saab 2.0T below 0.19 V for 4 s, Ford petrol below 0.19 V for 5 s, Ford diesel below 0.1 V. GM petrol needs two trips, GM diesel one. A modelled value replaces the reading.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 07

Possible causes

  • Connector unplugged or corroded, signal or reference wire open high
  • Signal wire shorted to ground (chafing) high
  • 5 V reference shorted by another faulty sensor on the same circuit medium
  • MAP sensor failed internally medium
  • Engine control module faulty low

Symptoms

  • Check engine light on
  • Hard starting, rough idle, stalling possible
  • Wrong mixture from substitute value, higher consumption
  • Loss of power or limp mode on turbo and diesel engines

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0107

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication