OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0106

Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Range/Performance

The manifold absolute pressure (MAP) sensor measures the pressure behind the throttle; on vehicles without a separate barometric sensor it also supplies the ambient pressure, read at key-on or wide-open throttle – hence 'MAP/BARO'. It is a three-wire sensor with 5 V reference, ground and signal. P0106 is a plausibility fault: the signal is electrically valid but implausible – stuck, offset or drifting. Two tests are common. With the engine stopped, all pressures equalise, so MAP must match ambient (and boost) pressure; Ford allows 1.5–3 inHg. While running, MAP is compared with a value modelled from air mass, throttle and speed – GM blames the MAP sensor above about 23–30 kPa error, with two trips on petrol and one on diesel. Turbo engines with three sensors find the odd one out by majority. Besides the sensor, intake or boost leaks often cause it.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 06

Possible causes

  • Vacuum leak at the intake manifold or boost leak (hose, clamp, charge air cooler) high
  • Sensor oiled or sooted, port blocked (EGR soot), characteristic drifted high
  • High resistance in signal, reference or ground wire medium
  • Comparison sensor wrong, or mechanical cause (dirty throttle, EGR stuck open) medium

Symptoms

  • Check engine light on
  • Rough idle, hesitation, poor response
  • Higher consumption, black smoke possible on diesels
  • Loss of power or limp mode on turbo engines

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0106

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication