OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0105

Manifold Absolute Pressure/Barometric Pressure Sensor Circuit

The manifold absolute pressure (MAP) sensor measures the pressure behind the throttle; on vehicles without a separate barometric sensor it also supplies the ambient pressure, read at key-on or wide-open throttle – hence 'MAP/BARO'. It is a three-wire sensor with 5 V reference, ground and signal. P0105 is the general circuit fault and is rarely used today: most petrol engines report low, high and intermittent separately (P0107–P0109). It appears mainly where the fault cannot be broken down further – Ford's 2023 diesels set it when the digital SENT sensor reports a bad status or an out-of-limit value for 5 s (lost communication is a separate U code), and Bosch EDC16 diesels use it with a fault type byte, for example signal below 0.2 V. Saab then substitutes 101.3 kPa, limits torque and switches off EGR and boost control.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 05

Possible causes

  • Connector or wiring to the sensor open, shorted or loose high
  • MAP sensor faulty (oiled, failed internally, SENT status fault) medium
  • Sensor hose disconnected, vacuum or boost leak medium
  • 5 V reference pulled down by another sensor on the same circuit low
  • Engine control module faulty low

Symptoms

  • Check engine light on
  • Loss of power, limp mode with torque limit (diesel)
  • Rough idle, hard starting, higher consumption (petrol)
  • Smoke possible on diesels

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0105

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication