OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0100

Mass or Volume Air Flow Sensor A Circuit

The mass air flow sensor (MAF) sits between the air filter and the throttle or compressor and measures how much air the engine draws in; fuel quantity, load and ignition are calculated from it. Most are hot-film or hot-wire sensors that output either a voltage or, on GM, Saab and newer Ford systems, a frequency. P0100 means the control module gets no usable signal at all. Ford uses it for a broken sensing element on digital sensors (period longer than 1.3 ms, i.e. below about 0.78 kHz, for half a second); on GM's 3.0 V6 in the Saab 9-4X it is set at 0 Hz. Many systems with voltage sensors skip P0100 and report low or high directly. The engine then runs on air mass calculated from manifold pressure, throttle angle and speed; Ford also disables start-stop.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 00

Possible causes

  • Connector unplugged or corroded, signal or supply wire open high
  • Sensor faulty internally (broken element, failed electronics) high
  • Supply fuse or relay failed medium
  • Control module input faulty low

Symptoms

  • Check engine light on
  • Rough idle, hesitation, lack of power (substitute value)
  • Hard starting or stalling
  • Higher fuel consumption

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0100

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication