P00FB
Turbocharger Outlet Pressure Sensor A Circuit High
The turbocharger outlet pressure sensor A measures the pressure directly after the compressor, usually ahead of the charge air cooler; FCA fits it as a combined temperature and pressure sensor. Boost control and compressor protection use the value. P00FB means the signal voltage is above its valid range: typically a signal wire shorted to the 5 V reference or battery voltage, an open ground, or a failed sensor. It does not mean the boost really is too high – that would be P0234. The circuit is monitored continuously from key-on; comparable GM pressure sensors fail above 86–97 % of the reference for about 4 s. The engine then works with a substitute value and may limit boost. GM and Ford do not use this code family in their published summaries – they rely on the boost sensor ahead of the throttle (P0235–P0238) – so no manufacturer document naming exactly this code was found.
Possible causes
- Signal wire shorted to 5 V reference or battery voltage high
- Ground (low reference) wire open or connector corroded medium
- Sensor faulty internally (oil mist, heat at compressor outlet) medium
- Engine control module faulty low
Symptoms
- Check engine light on
- Loss of power or limp mode with boost limit
- Further pressure plausibility codes possible
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P00FB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.