OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P00FA

Turbocharger Outlet Pressure Sensor A Circuit Low

The turbocharger outlet pressure sensor A measures the pressure directly at the compressor outlet. It is a separate code family from the boost pressure sensor, which usually measures the pressure just ahead of the throttle; engines use it where the pressure behind the compressor is needed in addition, for example to judge the pressure loss across the charge air cooler or to protect against compressor surge. One manufacturer documents it as a combined temperature and pressure sensor. P00FA means the signal is below its valid range, typically an open circuit, a short to ground or a missing 5 V reference. None of the published manufacturer documents searched uses this code; the explanation follows regulations and comparable manufacturer monitors.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / FA

Possible causes

  • Connector loose or not fully engaged, or sensor not seated properly high
  • Wire interrupted, short to ground or 5 V reference missing high
  • Leak at the sensor flange or seal medium
  • Engine control module faulty low

Symptoms

  • Check engine light on
  • Loss of power or limp mode with boost limitation
  • Jerking under load possible

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P00FA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication