P00F0
Intake Air Temperature Sensor 3 Circuit High Bank 2
Intake air temperature sensor 3 is a third air temperature sensor in the intake path. On documented turbocharged engines with a humidity sensor it is the manifold temperature sensor behind the charge air cooler, an NTC thermistor read directly by the engine control module and used for cylinder filling and ignition timing. The numbering of intake air temperature sensors differs between manufacturers. P00F0: The signal is above its valid range, i.e. very high resistance from an open circuit; the control module then reads an extremely low temperature. No manufacturer description naming this exact code was found; bank 2 codes are intended for engines with two separate intake paths.
Possible causes
- Open circuit, connector off or corroded high
- Sensor open internally medium
- Ground wire interrupted or control module faulty low
Symptoms
- Check engine light on
- Usually no noticeable symptoms; substitute value used
- Slightly reduced power through knock protection possible
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P00F0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.