P00E7
Intake Air Temperature Measurement System - Multiple Sensor Correlation Bank 2
After a long standstill (six hours in a documented case) all intake air temperature sensors, for example intake air, charge air cooler and manifold temperature, should read about the same. The control module compares them in pairs: if one sensor stands out, it sets that sensor's own plausibility code. This code is set when no pair agrees, so no single sensor can be identified as faulty. A detected engine preheater suspends the test. Since it runs only after a long standstill, the code may take a night to return after being cleared. No manufacturer description naming this exact code was found; bank 2 codes are intended for engines with two separate intake paths.
Possible causes
- One temperature sensor drifting without setting its own code medium
- Uneven cooling, undetected preheater or strong sunshine medium
- Shared ground or reference line disturbed, falsifying several sensors medium
- Engine control module or software low
Symptoms
- Check engine light on
- Usually no drivability symptoms
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P00E7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.