OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P00D8

Turbocharger/Supercharger Bypass Valve B Temperature Too High

Bypass valve B is the electric compressor recirculation valve, mounted close to the hot compressor and turbine housing. This code reports that its temperature is too high. How the temperature is detected is not described in published manufacturer documents; a documented principle for comparable turbocharger solenoids estimates the coil temperature from current, supply voltage and duty cycle and protects the coil by limiting or switching it off. With the valve switched off, the compressor may surge when lifting off the throttle. None of the published manufacturer documents searched uses this code; the explanation follows regulations and comparable manufacturer monitors.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / D8

Possible causes

  • Valve energised for unusually long periods, e.g. due to boost control problems medium
  • Coil with shorted turns or aged medium
  • Heat shield missing or exhaust leak near the turbocharger medium
  • Contact resistance or supply fault distorting the estimate low

Symptoms

  • Check engine light on (manufacturer-dependent)
  • Whistling or fluttering when lifting off the throttle
  • Slight loss of power

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P00D8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication