P00D5
HO2S Sensor Correlation Bank 1 Sensor 1/Bank 1 Sensor 2
During fuel cut-off on overrun the exhaust gas is pure air, so the oxygen sensors before and behind the catalytic converter must both report the same lean value. A documented method averages and normalises the signals of both sensors during fuel cut-off and sets the code when they differ by more than a limit; it runs once per drive cycle and needs several overrun phases. The code points to one of the sensors having drifted, not to the catalytic converter. The manufacturer documenting it uses wide-band sensors in both positions.
Possible causes
- Upstream sensor aged or shifted high
- Downstream sensor aged or shifted high
- Air or exhaust leak between the sensors falsifying the lean signal medium
- Retrofitted sensor with wrong characteristic, or software low
Symptoms
- Check engine light on
- Usually no noticeable drivability problem
- Catalyst readiness may stay incomplete
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P00D5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.