P00D4
HO2S Heater Control Circuit Range/Performance Bank 2 Sensor 2
This code concerns the heated oxygen sensor behind the catalytic converter (sensor 2) on bank 2. Unlike the heater circuit codes, which report an open or short circuit, this code means the heater is driven but does not bring the oxygen sensor to the expected temperature. One documented method, used where no current-measuring shunt is fitted, measures the internal impedance of the sensor element: a hot element has a low impedance. If the impedance stays above a limit that depends on the calculated element temperature and the voltage at the sensor connector, the heating is judged insufficient. The test runs once per trip. Typical causes are an aged heating element or added resistance from corrosion in the heater circuit. Bank 2 exists only on V and boxer engines.
Possible causes
- Heating element aged, resistance increased high
- Corrosion or contact resistance at connector or harness of the heater circuit high
- Too low supply voltage at the sensor connector, e.g. poor ground medium
- Diagnostic software (manufacturer updates exist for some vehicles) medium
- Replacement sensor with a different heater low
Symptoms
- Check engine light on
- Usually no noticeable drivability problem
- Oxygen sensor heater readiness stays incomplete
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P00D4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.