P00B0
Turbocharger/Supercharger Boost Control B Module Performance
Boost control B here is an electronic actuator with its own electronics (a "smart" actuator), usually on the variable turbine geometry, with its own position sensor and controlled over a data bus or a pulsed signal. It checks itself and reports internal faults to the engine control module; documented examples are pattern errors, overcurrent and checksum errors. The control module cannot narrow down a fault inside the actuator further. B denotes the second, separate actuator. P00B0 is set when actuator B reports an internal fault. No manufacturer description naming this exact code was found; the explanation follows its documented counterpart.
Possible causes
- Electronics or motor inside the actuator faulty high
- Sector gear or vane mechanism sticking (soot, coking), causing overcurrent medium
- Weak supply or ground, corroded connector medium
- Software of actuator or control module low
Symptoms
- Check engine light on
- Loss of power or limp mode with reduced boost
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P00B0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.