P00A2
Charge Air Cooler Temperature Sensor Circuit Low Bank 2
The charge air cooler temperature sensor for bank 2 (an NTC thermistor) measures the charge air temperature in the second charge-air path, for example on V engines with two charge air coolers. The engine control module uses it for the air mass calculation, boost control and component protection. For P00A2, the sensor signal is below its valid range. With the usual voltage-type NTC sensor this means a short to ground, and the control module reads an extremely high temperature; some manufacturers use sensors with a frequency output, where a low signal instead corresponds to an extremely low temperature (open circuit or short to ground). Bank 2 codes occur only on engines with two separate intake or charge-air paths, one per cylinder bank.
Possible causes
- Sensor shorted internally or signal wire shorted to ground high
- Connector damp or corroded medium
- On frequency-output sensors: open circuit medium
- Engine control module faulty low
Symptoms
- Check engine light on
- Usually no noticeable symptoms
- Slightly changed power or knock control with an implausible reading
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P00A2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.