Powertrain
generic / SAE
P009D
Fuel Pressure Relief Control Circuit High
Pressure relief solenoid control voltage above expected range — short to power or open ground. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 9D
Possible causes
- Wiring shorted to battery high
- Connector pins corroded - high contact resistance low
- Supply wire pinched against B+ source low
Symptoms
- Check engine light on
- Hard start, no start, or stalling under load
- Power loss especially at high load or rpm
- Possible long cranking time
Inspection / repair
- Difficulty: medium
- DIY: possible
- Estimated cost: 80–500 €
- Estimated time: 0.5–3 h
- Component: pressure relief solenoid
- Component: solenoid wiring
- MIL / check engine light
- emissions-relevant
Sources
References
sae:J2012