P0090
Fuel Pressure Regulator A Control Circuit/Open
On common-rail diesel and gasoline direct-injection engines, a high-pressure pump feeds the fuel rail, a sensor measures rail pressure, and the engine control module regulates it towards a target from its maps. The fuel pressure regulator A is the actuator the manufacturer designates for this: depending on the system a pressure control valve that releases fuel from the rail, or the control valve on the high-pressure pump. Some manufacturers report the pump valve under the "fuel volume regulator" codes instead. P0090 is the general circuit fault, usually an open circuit: the driver voltage or current does not fit the command. Rail pressure can then no longer be controlled as intended, and the engine usually runs in reduced power.
Possible causes
- Wire broken or connector corroded or loose high
- Regulator coil faulty high
- Fuse or supply voltage faulty medium
- Output driver in the engine control module faulty low
Symptoms
- Check engine light on
- Reduced power mode
- Hard starting or stalling
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0090
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p0090-p0091-or-p0092
- saabwisonline.com/9-5-9650/2011/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p0090-p0091-or-p0092
- gsi.ext.gm.com/gmspo/mode6/pdf/2001/2001file9.pdf