P0086
Exhaust Valve Control Solenoid Circuit High Bank 2
A solenoid valve on the cylinder head controls oil flow for the variable valve control on the exhaust side of bank 2. Depending on the manufacturer it drives a camshaft phaser (for example on Nissan engines) or a valve lift changeover (for example on Subaru engines). This code family reports electrical faults in its control circuit; P0086 means the voltage in the control circuit is too high, typically a short to battery voltage. Other manufacturers report the same valve under the "camshaft position actuator" codes instead. Valve control is then switched off or stays in its base position. Bank 2 exists only on V and boxer engines.
Possible causes
- Control wire shorted to battery voltage high
- Solenoid coil faulty medium
- Water or corrosion in the connector medium
- Output driver in the engine control module faulty low
Symptoms
- Check engine light on
- Less power, especially at high engine speed with lift changeover
- Rough idle possible
- Follow-up codes for camshaft timing or misfire possible
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0086
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.