OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0085

Exhaust Valve Control Solenoid Circuit Low Bank 2

A solenoid valve on the cylinder head controls oil flow for the variable valve control on the exhaust side of bank 2. Depending on the manufacturer it drives a camshaft phaser (for example on Nissan engines) or a valve lift changeover (for example on Subaru engines). This code family reports electrical faults in its control circuit; P0085 means the voltage in the control circuit is too low, typically a short to ground; depending on the driver stage an open solenoid winding can also set this code. Other manufacturers report the same valve under the "camshaft position actuator" codes instead. Valve control is then switched off or stays in its base position. Bank 2 exists only on V and boxer engines.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 85

Possible causes

  • Control wire shorted to ground, or solenoid winding open (driver-dependent) high
  • Shorted turns in the solenoid coil medium
  • Corroded or oil-soaked connector medium
  • Output driver or supply in the engine control module faulty low

Symptoms

  • Check engine light on
  • Less power, especially at high engine speed with lift changeover
  • Rough idle possible
  • Follow-up codes for camshaft timing or misfire possible

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0085

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication