OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0083

Intake Valve Control Solenoid Circuit High Bank 2

A solenoid valve on the cylinder head controls oil flow for the variable valve control on the intake side of bank 2. Depending on the manufacturer it drives a camshaft phaser (for example on Nissan engines) or a valve lift changeover (for example on Subaru engines). This code family reports electrical faults in its control circuit; P0083 means the voltage in the control circuit is too high, typically a short to battery voltage. Other manufacturers report the same valve under the "camshaft position actuator" codes instead. Valve control is then switched off or stays in its base position. Bank 2 exists only on V and boxer engines.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 83

Possible causes

  • Control wire shorted to battery voltage high
  • Solenoid coil faulty medium
  • Water or corrosion in the connector medium
  • Output driver in the engine control module faulty low

Symptoms

  • Check engine light on
  • Less power, especially at high engine speed with lift changeover
  • Rough idle possible
  • Follow-up codes for camshaft timing or misfire possible

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0083

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication