P0080
Exhaust Valve Control Solenoid Circuit High Bank 1
A solenoid valve on the cylinder head controls oil flow for the variable valve control on the exhaust side of bank 1. Depending on the manufacturer it drives a camshaft phaser (for example on Nissan engines) or a valve lift changeover (for example on Subaru engines). This code family reports electrical faults in its control circuit; P0080 means the voltage in the control circuit is too high, typically a short to battery voltage. Other manufacturers report the same valve under the "camshaft position actuator" codes instead. Valve control is then switched off or stays in its base position.
Possible causes
- Control wire shorted to battery voltage high
- Solenoid coil faulty medium
- Water or corrosion in the connector medium
- Output driver in the engine control module faulty low
Symptoms
- Check engine light on
- Less power, especially at high engine speed with lift changeover
- Rough idle possible
- Follow-up codes for camshaft timing or misfire possible
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0080
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.