OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0077

Intake Valve Control Solenoid Circuit High Bank 1

A solenoid valve on the cylinder head controls oil flow for the variable valve control on the intake side of bank 1. Depending on the manufacturer it drives a camshaft phaser (for example on Nissan engines) or a valve lift changeover (for example on Subaru engines). This code family reports electrical faults in its control circuit; P0077 means the voltage in the control circuit is too high, typically a short to battery voltage. Other manufacturers report the same valve under the "camshaft position actuator" codes instead. Valve control is then switched off or stays in its base position.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 77

Possible causes

  • Control wire shorted to battery voltage high
  • Solenoid coil faulty medium
  • Water or corrosion in the connector medium
  • Output driver in the engine control module faulty low

Symptoms

  • Check engine light on
  • Less power, especially at high engine speed with lift changeover
  • Rough idle possible
  • Follow-up codes for camshaft timing or misfire possible

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0077

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication