P0068
MAP/MAF - Throttle Position Correlation
The engine control module compares the air quantity measured by the manifold pressure and/or mass air flow sensor with the quantity the throttle position leads it to expect. P0068 is set when they do not match, typically because more air arrives than the nearly closed throttle allows, i.e. an air leak behind the throttle, or because the throttle body is dirty or a sensor reads wrong. On engines with electronic throttle this check protects throttle control, so the engine often goes into reduced power. Each sensor can be electrically fine on its own; regulations require such plausibility checks for input sensors with a code of their own.
Possible causes
- Air leak behind the throttle: intake manifold, vacuum or MAP hoses high
- Throttle body dirty high
- Mass air flow or manifold pressure sensor faulty medium
- Engine control software (manufacturer updates exist) medium
- Camshaft timing out of position low
Symptoms
- Check engine light on
- Reduced power mode
- Rough or unstable idle
- Jerking
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0068
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 5 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- gsi.ext.gm.com/gmspo/mode6/pdf/2019/19OBDG03A Diagnostics.pdf
- newtonnet.co.uk/fiesta/fordobd2012.pdf
- saabwisonline.com/9-5-9650/2011/2-engine/engine-management-and-fuel-system-2-0-l-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p0068-or-p1101
- static.nhtsa.gov/odi/tsbs/2020/MC-10178748-9999.pdf
- static.nhtsa.gov/odi/tsbs/2020/MC-10179236-0001.pdf