OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P005C

B Camshaft Profile Actuator A Control Performance/Stuck Off Bank 2

The camshaft profile actuator A switches the exhaust camshaft (camshaft B) on bank 2 between fixed cam profiles, usually a low-lift base profile and a high-lift profile. In most designs the unactuated state ("off") is the base profile; which profile counts as "on" is defined by the manufacturer. The control module does not need a position sensor to check the switchover: it detects the actual profile indirectly, for example from oil pressure in the switching gallery, intake pressure per cylinder or crankshaft speed fluctuations. This code is set when the switchover is commanded but the camshaft stays on the base profile, or switches too slowly or incompletely. The engine then lacks power at higher engine speed. Bank 2 exists only on V and boxer engines.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 5C

Possible causes

  • Oil level too low, wrong viscosity or sludged oil, so switching pressure is missing high
  • Profile switching solenoid sticking or its screen clogged high
  • Oil supply to the switching elements leaking or restricted, e.g. worn seals medium
  • Locking pin in tappet or rocker arm, or sliding cam piece, sticking medium
  • Consequence of a circuit fault of the same actuator low

Symptoms

  • Check engine light on
  • Lack of power at higher engine speed
  • Reduced power mode on some vehicles

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P005C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication