P005B
B Camshaft Profile Actuator A Control Stuck On Bank 1
The camshaft profile actuator A switches the exhaust camshaft (camshaft B) on bank 1 between fixed cam profiles, usually a low-lift base profile and a high-lift profile. In most designs the unactuated state ("off") is the base profile; which profile counts as "on" is defined by the manufacturer. The control module does not need a position sensor to check the switchover: it detects the actual profile indirectly, for example from oil pressure in the switching gallery, intake pressure per cylinder or crankshaft speed fluctuations. This code is set when the base profile is commanded but the camshaft stays on the switched profile. Large lift and long opening at low engine speed cause rough idle and poor low-speed running.
Possible causes
- Profile switching solenoid stuck open, oil pressure is not released high
- Locking pin does not return (weak spring, burr or dirt) medium
- Oil pressure too high or drain from the switching gallery blocked medium
- Sliding cam piece stuck in the high-lift position low
Symptoms
- Check engine light on
- Rough idle and jerking at low engine speed
- Poor running when cold
- Misfire codes possible
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P005B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.