P0055
HO2S Heater Resistance Bank 1 Sensor 3
On bank 1, this monitor checks the heating element of sensor 3 further downstream not for an open or short circuit, but for its resistance. Many systems measure it once after a genuine cold start, when coolant and intake air temperatures show that the sensor is at ambient temperature, and correct the value for temperature; some manufacturers evaluate the heater current instead. The code is set when the value lies outside the limits for this sensor type, typically because the element has aged. Since the test often runs only after a long standstill, the code may take a night to confirm or clear.
Possible causes
- Heating element aged or partly damaged high
- Contact resistance or corrosion at connector or pins medium
- Replacement sensor with a different heater type fitted medium
- Engine control module faulty low
Symptoms
- Check engine light on, sometimes only after a cold start
- Readiness for the sensor heater stays incomplete
- Usually no drivability symptoms
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0055
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.