OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0051

HO2S Heater Control Circuit Low (Bank 2 Sensor 1)

The heated oxygen sensor on bank 2 is the upstream sensor (sensor 1, before the catalytic converter), used for mixture control. Its heating element brings it quickly to operating temperature. Typically the heater receives battery voltage via a fuse, and the engine control module switches the ground side with a pulsed signal while checking that the circuit state matches the command. P0051 means the control module measures too low a voltage or current in the heater control circuit, for example because of a short to ground or, depending on the system, a burnt-out element. Which physical fault sets the general, low or high code is defined by each manufacturer. Without heating, closed-loop mixture control starts late and cold-start emissions rise. Bank 2 codes occur only on engines with two exhaust banks (V or boxer engines).

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 51

Possible causes

  • Control wire shorted to ground, or heating element burnt out (system-dependent) high
  • Supply interrupted or fuse blown medium
  • Corroded connector with high contact resistance medium
  • Output driver or software of the engine control module low

Symptoms

  • Check engine light on
  • Usually no noticeable drivability problem
  • Closed-loop control starts late after a cold start
  • Emissions test or readiness check failed

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0051

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication