OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0036

HO2S Heater Control Circuit (Bank 1 Sensor 2)

The heated oxygen sensor on bank 1 is the downstream sensor 2 behind the (first) catalytic converter, used mainly to monitor the converter. Its heating element brings it quickly to operating temperature. Typically the heater receives battery voltage via a fuse, and the engine control module switches the ground side with a pulsed signal while checking that the circuit state matches the command. P0036 is the general circuit fault: the measured state of the heater circuit does not fit the command, most often because the circuit is interrupted. Which physical fault sets the general, low or high code is defined by each manufacturer. Without heating, the sensor becomes ready late and catalyst monitoring may not complete.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 36

Possible causes

  • Heating element inside the sensor burnt out high
  • Wire or connector damaged by heat or road spray high
  • Heater fuse blown; a shared fuse can set several heater codes medium
  • Output driver or software of the engine control module low

Symptoms

  • Check engine light on
  • Usually no noticeable drivability problem
  • Catalyst monitor does not complete
  • Emissions test or readiness check failed

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0036

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication