P0035
Turbocharger/Supercharger Bypass Valve A Control Circuit High
The turbocharger bypass valve A is the compressor recirculation (diverter) valve: it connects the pressure side of the compressor with the intake side upstream of the turbocharger. It opens when the throttle closes quickly at high boost, so the compressor does not surge and the compressor wheel keeps its speed for the next acceleration. It is not the wastegate, which bypasses exhaust gas around the turbine and has its own codes. The valve is either electric or a vacuum unit controlled by a solenoid. P0035 means the voltage at the control output is too high, typically a short to battery voltage; on some engines an intermittent break in the harness has also set this code.
Possible causes
- Control wire shorted to battery voltage high
- Loose contact or broken wire, e.g. harness vibrating from heat medium
- Solenoid coil faulty medium
- Output driver in the engine control module faulty low
Symptoms
- Check engine light on
- Fluttering or hissing when lifting off the throttle if the valve stays closed
- Weak response after gear changes
- Too little boost if the valve stays open
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0035
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG03A Engine Diagnostics.pdf
- saabwisonline.com/9-5-9650/2011/2-engine/engine-management-and-fuel-system-2-0-l-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p0033-p0035
- static.nhtsa.gov/odi/tsbs/2018/MC-10142655-9999.pdf