OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0031

HO2S Heater Control Circuit Low (Bank 1 Sensor 1)

The upstream oxygen sensor on bank 1 (sensor 1, before the catalytic converter) only delivers a usable signal once its ceramic element is hot. A heating element inside the sensor gets it there quickly after a cold start. Typically the heater receives battery voltage via a fuse or relay, and the engine control module switches the ground side with a pulsed signal while comparing the commanded state with the measured voltage or current. P0031 means the control module measures too little voltage or current while the heater is switched on. Depending on the system this points to a burnt-out element, a missing supply or an interrupted control wire. The sensor then warms up late, so mixture control starts late and cold-start emissions rise.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 31

Possible causes

  • Heating element burnt out or high resistance (too little current) high
  • Supply wire interrupted or fuse blown high
  • Control wire to the engine control module interrupted medium
  • Corroded connector with high contact resistance medium
  • Output driver in the engine control module faulty low

Symptoms

  • Check engine light on
  • Closed-loop control starts late after a cold start
  • Further heater codes if a shared fuse has blown
  • Emissions test or readiness check failed

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0031

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication