OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0023

"B" Camshaft Position Actuator Circuit (Bank 2)

The engine control module drives the oil control valve (a pulse-width modulated solenoid) of the variable valve timing on the exhaust camshaft on bank 2. It checks the electrical state of this output and sets the code when the circuit is open, or when the measured state does not match the command, for example because of a short. Camshaft adjustment is then disabled and the phaser stays in its locked rest position: the engine keeps running, but with less torque and higher consumption. Bank 2 exists only on V and boxer engines; it is the cylinder bank without cylinder 1.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 23

Possible causes

  • Solenoid coil of the oil control valve open or shorted high
  • Connector corroded, loose or soaked with engine oil wicking through the valve high
  • Wiring harness chafed through or broken medium
  • Supply voltage missing, e.g. blown fuse medium
  • Output driver in the engine control module faulty low

Symptoms

  • Check engine light on
  • Less pulling power at low and medium engine speed
  • Rough idle in some engines
  • Slightly higher fuel consumption

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0023

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication