P001E
A Camshaft Profile Actuator A Control Circuit Low Bank 2
A camshaft profile actuator switches the intake camshaft (camshaft A) on bank 2 between two or more fixed cam profiles with different valve lift and duration, for example by shifting a cam piece axially or by locking rocker arms or tappets with oil pressure. Unlike a camshaft phaser it does not shift the timing continuously. The second letter "A" in the title numbers the actuator on this camshaft. This code is set when the control circuit reads too low, typically because the control wire is shorted to ground. The engine usually stays on one profile, typically the base profile with low lift. Some manufacturers report these faults with their own codes instead. Bank 2 exists only on V and boxer engines.
Possible causes
- Control wire chafed through and shorted to ground high
- Connector corroded or contaminated with oil medium
- Shorted turns in the actuator coil medium
- Output driver in the engine control module faulty low
Symptoms
- Check engine light on
- Less power at high engine speed because the profile does not switch
- Higher consumption or uneven part-load running, depending on the profile
- Engine speed may be limited
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P001E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.