OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0019

Crankshaft Position - Camshaft Position Correlation (Bank 2 Sensor B)

The engine control module checks whether the signal of the exhaust camshaft on bank 2 (sensor B) arrives at the expected crankshaft position, usually while the camshaft phaser is in its rest position. P0019 is set when the deviation stays outside a calibrated window. The camshaft is then out of step with the crankshaft: a timing belt or chain has jumped a tooth, the chain is stretched, the phaser is stuck at an end stop, or a reluctor wheel has slipped. On engines with a single camshaft, sensor A is simply the only camshaft sensor. Bank 2 exists only on V and boxer engines.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 19

Possible causes

  • Timing chain stretched, or belt or chain jumped a tooth high
  • Camshaft phaser stuck at an end stop, oil control valve or oil pressure faulty medium
  • Incorrect assembly after a belt or chain replacement medium
  • Camshaft or crankshaft sensor signal disturbed low
  • Reluctor wheel on crankshaft or camshaft slipped low

Symptoms

  • Check engine light on
  • Long cranking or hard starting
  • Rough idle and loss of power
  • Chain rattle at cold start on chain-driven engines
  • Risk of valve damage on interference engines if the timing has jumped

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0019

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 5 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication