P0017
Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor B)
The engine control module checks whether the signal of the exhaust camshaft on bank 1 (sensor B) arrives at the expected crankshaft position, usually while the camshaft phaser is in its rest position. P0017 is set when the deviation stays outside a calibrated window. The camshaft is then out of step with the crankshaft: a timing belt or chain has jumped a tooth, the chain is stretched, the phaser is stuck at an end stop, or a reluctor wheel has slipped. On engines with a single camshaft, sensor A is simply the only camshaft sensor.
Possible causes
- Timing chain stretched, or belt or chain jumped a tooth high
- Camshaft phaser stuck at an end stop, oil control valve or oil pressure faulty medium
- Incorrect assembly after a belt or chain replacement medium
- Camshaft or crankshaft sensor signal disturbed low
- Reluctor wheel on crankshaft or camshaft slipped low
Symptoms
- Check engine light on
- Long cranking or hard starting
- Rough idle and loss of power
- Chain rattle at cold start on chain-driven engines
- Risk of valve damage on interference engines if the timing has jumped
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0017
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 5 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- gsi.ext.gm.com/gmspo/mode6/pdf/2016/16OBDG05 Engine Diagnostics.pdf
- saabwisonline.com/9-4x/2011/2-engine/engine-management-and-fuel-system-v6/fault-diagnosis-diagnostic-trouble-codes/dtc-p0016-p0017-p0018-or-p0019-without-lf1-lfw
- static.nhtsa.gov/odi/tsbs/2014/SB-10069486-0335.pdf
- WikipediaCrankshaft position sensor
- WikipediaTiming belt (camshaft)