OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0015

"B" Camshaft Position - Timing Over-Retarded (Bank 1)

The engine control module compares the commanded position of the exhaust camshaft on bank 1 with the actual position from the camshaft and crankshaft sensors. This code is set when the camshaft stays further retarded than commanded for longer than a calibrated time. Usually the phaser does not move far enough out of its rest position, because oil pressure is too low to release the locking pin, the oil control valve does not open, or the oil screen is blocked. A stretched timing chain also shifts the camshaft towards retarded. Bank 1 is the cylinder bank that contains cylinder 1.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 15

Possible causes

  • Oil pressure or oil level too low, oil worn out high
  • Oil control valve sticking closed or its screen blocked high
  • Cam phaser defective or seized in its rest position medium
  • Timing chain stretched or jumped a tooth medium
  • Wear debris in the oil circuit, e.g. from a thrust bearing low

Symptoms

  • Check engine light on
  • Noticeably less torque and pulling power
  • Higher fuel consumption
  • Harder starting in some cases
  • Rattle from the timing drive if the chain is stretched

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0015

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication