OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P000E

Fuel Volume Regulator Control Exceeded Learning Limit

The fuel volume regulator (also called metering unit or suction control valve) is a solenoid valve on the inlet side of the high-pressure pump, used mainly on common-rail diesel engines. The engine control module pulses it to set how much fuel the pump draws in and delivers to the rail, and in this way controls rail pressure. To compensate for tolerances and wear, the control module learns a long-term correction of the regulator control. P000E is set when this correction leaves its calibrated range. The regulator is electrically fine, but the system needs an unusually large correction all the time, which points to wear or contamination of regulator or pump, a weak low-pressure supply, or a missing calibration after a pump replacement.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 0E

Possible causes

  • Fuel volume regulator worn or contaminated high
  • High-pressure pump worn, delivering less medium
  • Low-pressure side: clogged filter, weak lift pump or air in the fuel medium
  • Not calibrated after pump or regulator replacement medium
  • Rail pressure sensor drifting low

Symptoms

  • Check engine light on
  • Often hardly noticeable at first, later loss of power
  • Hard starting if rail pressure is wrong
  • Additional rail pressure codes possible

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P000E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication