OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0004

Fuel Volume Regulator A Control Circuit High

The fuel volume regulator (also called metering unit or suction control valve) is a solenoid valve on the inlet side of the high-pressure pump, used mainly on common-rail diesel engines. The engine control module pulses it to set how much fuel the pump draws in and delivers to the rail, and in this way controls rail pressure. P0004 means the voltage on the control circuit stays too high for the commanded duty cycle, typically because of a short to battery voltage, or, with a switched ground side, an open circuit. The valve can then not be energised; a normally open design delivers maximum fuel and rail pressure rises.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 04

Possible causes

  • Short to battery voltage in the harness high
  • Open coil or wire, reported as high with ground-side switching medium
  • Connector fault at the regulator medium
  • Output driver in the engine control module faulty low

Symptoms

  • Check engine light on
  • Loss of power or limp mode
  • Rough running or diesel knock possible
  • Excess rail pressure codes possible

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0004

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication