OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0003

Fuel Volume Regulator A Control Circuit Low

The fuel volume regulator (also called metering unit or suction control valve) is a solenoid valve on the inlet side of the high-pressure pump, used mainly on common-rail diesel engines. The engine control module pulses it to set how much fuel the pump draws in and delivers to the rail, and in this way controls rail pressure. P0003 means the control module measures a voltage or current below the expected range on the control circuit, typically because of a short to ground. On some output stages an open circuit is also reported as low. A short on the switched ground side can keep the valve permanently energised.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number– / 03

Possible causes

  • Harness chafed through, short to ground high
  • Shorted turns in the regulator coil (resistance too low) medium
  • Water or corrosion in the connector medium
  • Output driver in the engine control module faulty low

Symptoms

  • Check engine light on
  • Hard starting or stalling
  • Loss of power or limp mode
  • Low rail pressure code possible

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0003

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication