P0002
Fuel Volume Regulator A Control Circuit Range/Performance
The fuel volume regulator (also called metering unit or suction control valve) is a solenoid valve on the inlet side of the high-pressure pump, used mainly on common-rail diesel engines. The engine control module pulses it to set how much fuel the pump draws in and delivers to the rail, and in this way controls rail pressure. With P0002 the circuit is electrically intact, but command and effect do not match: the measured current does not fit the duty cycle, or rail pressure does not follow the regulator position plausibly. The cause is often mechanical, for example a sticking valve, rather than the wiring.
Possible causes
- Regulator sticking or worn due to dirt, debris or water in the fuel high
- High resistance at connector or wiring causing wrong current medium
- Low-pressure supply problem: clogged filter or air in the fuel medium
- Rail pressure sensor reading wrong values low
Symptoms
- Check engine light on
- Loss of power or limp mode
- Jerking or unstable idle
- Hard starting or stalling
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0002
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.