P0001
Fuel Volume Regulator A Control Circuit/Open
The fuel volume regulator (also called metering unit or suction control valve) is a solenoid valve on the inlet side of the high-pressure pump, used mainly on common-rail diesel engines. The engine control module pulses it to set how much fuel the pump draws in and delivers to the rail, and in this way controls rail pressure. P0001 is set when the control module detects that the control circuit of this valve is open, i.e. no plausible current flows when the valve is driven. Rail pressure can then no longer be controlled as intended. Whether the valve is open or closed without current depends on the design, so the same fault can cause excess pressure in one system and no pressure in another.
Possible causes
- Connector at the regulator loose, corroded or unplugged high
- Solenoid coil of the regulator open medium
- Broken wire in the harness, e.g. chafing or rodent damage medium
- Output driver in the engine control module faulty low
Symptoms
- Check engine light on
- Engine cranks but does not start, or stalls (normally closed valve)
- Loss of power or limp mode (normally open valve)
- Additional rail pressure codes possible
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0001
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.