OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0920

Suspension Control Module Internal Fault

C0920 is not found in any accessible list or bulletin. The title describes a suspension control unit that fails its own checks. GM names such a fault C0550 Electronic Control Unit, as the 2011 Saab 9-5 pages show: the self-test runs at power-up and needs only supply and ground, the module ignores further inputs, and it should only be replaced if the code is present as current and history entry; a history entry clears after 50 clean ignition cycles. Not every module swap is an internal fault: GM's PI0954 had 2010 LaCrosse suspension modules replaced because they did not accept service accelerometers, and Stellantis warns against replacing the damping module for stored codes. Audi logs C129700 for a limiting fault inside its roll stabiliser units.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number9 / 20

Possible causes

  • Internal hardware or memory fault confirmed as current and history code high
  • Poor supply or ground at the module triggering self-test failures medium
  • Software or parts incompatibility (GM PI0954, Audi 2067804/3) low

Symptoms

  • Suspension service message, adaptive damping or levelling off
  • Other suspension codes may be stored alongside

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0920

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication