C0905
TPMS Sensor 3 Battery Low
No manufacturer is known to use C0905; none of the code lists, service indexes or NHTSA bulletins searched contains it. The title names a weak battery in the third wheel transmitter. GM and Saab file this condition by wheel rather than by number, as subcode 03 Low Voltage under C0750 to C0765; on the 2011 Saab 9-5 the check needs more than 40 km/h, when a centrifugal roll switch puts each sensor into rolling mode and the door lock receiver forwards its data to the body module. Mitsubishi's counterpart for tire 3 is C1930, raised when the reception warning stems from low transmitter voltage. A low battery alone leaves pressures readable at first, so this is an early warning; the sensor will soon need replacing.
Possible causes
- Sensor cell near end of life (typically after many years) high
- Sensor stuck in a fast transmit mode, drawing the cell down early low
Symptoms
- TPMS lamp flashes about a minute after start, then stays on
- Pressure values still shown, warning returns after every restart
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0905
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.