OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0903

TPMS Sensor 2 Position Performance

Searches found C0903 neither in code lists nor in maker documents; a single NHTSA hit is a truck maker's campaign number. The title addresses locating transmitter 2 on the vehicle. Two methods are documented. A Ford patent puts a low frequency initiator into each wheel well: the controller fires it above about 20 mph, waits 3 seconds for the sensor to answer with its ID and a special status flag, raises the transmit power step by step and declares an error once the limit is reached without reply. A 2022 Mitsubishi system without initiators derives the position from the timing between the wheel speed sensors and each tire sensor. If either check ends without a clear match, the corner of sensor 2 stays unknown.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number9 / 03

Possible causes

  • Sensor does not answer the wheel well initiator (weak LF field, misaligned initiator) medium
  • Location learning interrupted, e.g. short trips at low speed after tire service high
  • Acceleration or rotation detection inside the sensor faulty low

Symptoms

  • TPMS lamp on with all tires correctly inflated
  • Display shows pressures without assigning them to wheel positions

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C0903

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication