OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0852

Active Damping Control Rear Left

Nothing public ties C0852 to a manufacturer; it is absent from every public list and index. The title covers the adjustable rear left damper. Some modern units use two valves per damper, one for compression and one for rebound. Stellantis does so on the 2024-26 Ram 1500 and Dodge Charger and logs the rear left pair as C15C6 and C15C7; its bulletin S2623000031 warns that these faults can only be diagnosed while active, so a module should not be replaced for stored entries, and tap tests on harness and pin fit come first. GM's older single-valve layout on the 2011 Saab 9-4X calls the same corner C0585. Rear dampers sit low and close to road spray, so plugs and cables there suffer most. Electronic damping is switched off until the fault clears.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number8 / 52

Possible causes

  • Loose pin fit or intermittent contact in the rear left damper connector high
  • Harness damaged by road spray, stones or corrosion near the rear axle medium
  • Compression or rebound valve in the damper failed medium

Symptoms

  • Service suspension warning
  • Rear feels bouncy or harsh, drive modes no longer change damping

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0852

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication