OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0827

Steering Effort Sensor Stuck

C0827 appears in no accessible code list, bulletin or manufacturer table, so no carmaker can be named for it. The title describes a steering torque signal that freezes: the value no longer follows the driver, either because a short pins the output at a supply rail or because the sensor delivers a constant value while the wheel is clearly being turned. An NSK patent shows how such a case is handled: outputs close to 0 V or 5 V (about 0.3 V and 4.7 V) count as faulty, the controller then works with the smallest of the last few good samples and fades assistance to zero over a set time rather than cutting it at once. Unlike the plausibility fault C0825, here the signal stops changing. The driver sees an EPS warning and the steering turns heavy within seconds.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number8 / 27

Possible causes

  • Sensor output shorted to supply or ground, holding the signal at a rail high
  • Hall element or sensor electronics frozen, usually requiring a new steering gear or column medium
  • Chafed or pinched harness between sensor and steering module low

Symptoms

  • Power steering warning lamp on
  • Assistance fades out and steering becomes heavy

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0827

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication