OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0805

Steering Angle Sensor Calibration

Public evidence for C0805 is lacking: it appears neither in code lists nor in the NHTSA index, GM's keyword table or the Saab and Mitsubishi indexes. The title describes a steering angle sensor whose zero point has not been learned. GM files exactly that fault elsewhere: in both 2011 Saab models, 9-5 and 9-4X, the brake module stores C0710 subcode 42 when the sensor reports no calibration, then switches off ESC and the hill holder until the next ignition cycle. Stellantis uses the J2012 code C0529 for the same condition on the ProMaster and advises an initialisation first, by turning lock to lock with the engine running or by scan tool, before any steering gear is replaced. The bulletin names a battery disconnect or a new steering gear as typical triggers for a fresh learn.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number8 / 05

Possible causes

  • Zero point not learned after battery disconnect or steering gear replacement high
  • Steering wheel or sensor mounted off centre, so the learned offset is out of range medium
  • Steering angle sensor defective and unable to store the calibration low

Symptoms

  • Stability or traction control lamp stays on
  • ESC and hill start assist unavailable

Inspection / repair

  • Difficulty: easy
  • DIY: shop recommended

What Pro shows you for C0805

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication