OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0750

Left Front Tire Pressure Sensor

None of the public code lists carries C0750. GM, however, uses it in its tire pressure monitoring for the left front wheel transmitter, and the Saab 9-5 (2010-2011) and 9-4X service pages define the subcodes: 03 for a weak sensor battery, 29 for a sensor that sends too few telegrams, 39 for an internal sensor defect. The check runs above 40 km/h, when the roll switch in each wheel unit should wake the transmitter; if it stays silent or its data are invalid, the body control module sets the code and the TPMS lamp blinks for a minute, then stays lit. GM bulletin PIC5650M lists C0750 among the effects of radio interference from add-on devices. C0755, C0760 and C0765 cover the other wheels. No evidence ties the code to a cruise control brake switch.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number7 / 50

Possible causes

  • Built-in battery of the wheel sensor exhausted (subcode 03) high
  • Sensor damaged during tire service, after a flat or replaced by a valve without sensor medium
  • Radio interference from aftermarket devices or metallised window tint (GM PIC5650M) medium
  • Remote receiver or its antenna unplugged or faulty low

Symptoms

  • TPMS lamp flashes about one minute after start, then stays on
  • Dashes instead of a pressure value for the left front tire
  • Service tire monitor message in the driver display

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C0750

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication