C0735
Electric Power Steering Module Internal Fault
No known public source uses C0735; it is absent from the published J2012 lists, from NHTSA bulletins and from maker indexes. Carmakers report an internal EPS controller fault under other codes. GM uses C056D as a general hardware fault and asks technicians to reprogram the module first when symptom 39 is set (PIT5213B, 2014-15 trucks and SUVs). Stellantis uses C2217-00; on the 2023 Wagoneer and Grand Wagoneer it came with loss of assist and a steering lamp and was improved by new software (08-147-23), while on the 2019 Cherokee bulletin 08-034-20 excludes cases where C2217 is active and assist is gone with the engine running. Nexteer stresses redundant hardware and parallel software paths so that a single internal fault does not remove all assist at once.
Possible causes
- Module software fault, cleared by reprogramming high
- Internal hardware failure of the EPS controller medium
- Wrong steering gear or module installed, setup not completed low
Symptoms
- Service power steering message, steering lamp on
- Assist reduced or absent from start-up
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C0735
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.